Description
Adaptor Kit suit GM 6L80E 6 Speed Auto to 60/70 Series LandCruiser 19 Spline Split Transfer
Adaptor Kit to adapt the GM 6L80E 6 Speed Automatic Transmission to Toyota LandCruiser 60,61,62 Series and any 70 Series running a 19 Spline ‘Split Transfer Case’. This transmission features two overdrive gears and a wide gear ratio spread to improve performance and fuel economy when compared with conventional four- and five-speed automatic transmissions. With two overdrive gears, engine rpm is reduced by approximately 9 percent at 60 mph – a reduction to about 1,500 rpm. GM estimates the wide ratio spread can help cut 0-60 mph times by as much as 7 percent and enhance fuel economy by up to 4 percent.
The modular design of the transmission permits several versions of the transmission to be tailored with minimal changes to the precise performance requirements of different vehicles. As many as 47 percent of all components are common for all four transmission variants. In fact, the new transmission design is so flexible that different variants theoretically could run sequentially down the same assembly line. The new six-speed automatic’s manufacturing plan dovetails completely with GM’s Global Manufacturing System strategy to implement a common manufacturing process and procedure at every worldwide GM assembly plant.
Technically sophisticated clutch-to-clutch operation reduces complexity and packaging. It also enhances the performance feel of the transmission, as shifts feel more immediate and precise. It is a simple, less complex design that enables the six-speed transmission to be packaged in a size not much larger than a four-speed automatic.
1 x TOY L/C FJ60 PLATE LARGE HOLE
1 x TOYOTA L/C- CIRCULAR 6 308 BEARING CASTING
1 x ADAPTER- ATLAS TO 6L80/6L90
1 x SHAFT- NV 32SP TO TLC 16SP
1 x BUSHING/GEAR LOCATOR
1 x 308 SEALED BEARING
1 x SPECIAL SNAP RING FOR 716310 BEARING
1 x GASKET (gasket I.D. must be trimmed to fit bearing)
1 x GASKET
6 x STUD BOLT 3/8 -16 X 2 LG B7
6 x NUT 3/8 -16 PLATED GRD 5
8 x 7/16″ FLATWASHERS
2 x 7/16″ H.H.C.S.
1 x H.H.C.S. 7/16″-14 x 3-1/2″ GR 5
2 x 724312 7/16″-14 x 4″ H.H.C.S.
2 x 7/16″-14 x 1-1/4″ H.H.C.S.
1 x METRIC SHAFT NUT 26-1.5
Fitting Notes
NOTE: 6.75″ stickout on a 2WD transmission. The shaft will need to be cut or shortened to 4.00 cut off.
